SS566A pdf datasheet

SS5 Series Hall effect position sensors are operated by the magnetic
field from a permanent magnet or electromagnet. The small SOT89 style
package surface mounts on PC boards and flexible circuits. The SS5 uses
a industry standard "gull-wing" design which makes it less susceptible to
"solder bridging" and allows increased circuit board density. The SS5
series package can accommodate larger IC’s than SS1 and allows for fourpin
designs
The integrated circuits are designed to provide predictable performance
over the full temperature range of -40 to +150°C. Bipolar, unipolar and
latching magnetics are available. The SS5 has the same footprint and pinout
as the industry standard SOT-89. It will replace Honeywell SS1 Series
and any equivalent SOT-89 sensors from other suppliers with minimum or
no design changes.
On-board regulation provides extremely stable operation over the full
supply voltage range of 4.5 to 24 VDC(SS51T) or 3.8 to 30 VDC(SS500).
Current consumption is a low 10 mA maximum at 40°C and is typically
7mA or less at room temperature and above. SS5 sensors are capable of
continuous 20 mA sinking output, and can withstand temporary current as
high as 20 mA maximum (SS51T) or 50 mA maximum (SS500). They can
use existing power supply sources in most applications, and can be directly
interfaced with many electronic components without buffering or
compensation circuitry.
SS5 Series sensors are supplied on tape and reel for high-volume,
automated pick and place equipment. Each reel contains 1,000 sensors.
MICRO SWITCH supplies bar and ring magnets for operating Hall effect
sensors. Bar magnets can operate any Hall effect sensor. Ring magnets
are magnetized on the outside diameter with alternating North and South
poles. They are particularly useful with bipolar sensors and rpm
measurement.