资料介绍
The TRS3243E device consists of three line drivers, five line receivers, and a dual charge-pump circuit with
± 15-kV ESD (HBM and IEC61000-4-2, Air-Gap Discharge) and ± 8-kV ESD (IEC61000-4-2, Contact Discharge)
protection on serial-port connection pins. The device meets the requirements of TIA/EIA-232-F and provides the
electrical interface between an asynchronous communication controller and the serial-port connector. This
combination of drivers and receivers matches that needed for the typical serial port used in an IBM PC/AT, or
compatible. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-V
supply. In addition, the device includes an always-active noninverting output (ROUT2B), which allows
applications using the ring indicator to transmit data while the device is powered down. The device operates at
data signaling rates up to 250 kbit/s and a maximum of 30-V/ µ s driver output slew rate.
Flexible control options for power management are available when the serial port is inactive. The
auto-powerdown feature functions when FORCEON is low and FORCEOFF is high. During this mode of
operation, if the device does not sense a valid RS-232 signal, the driver outputs are disabled. If FORCEOFF is
set low, both drivers and receivers (except ROUT2B) are shut off, and the supply current is reduced to 1 µ A.
Disconnecting the serial port or turning off the peripheral drivers causes the auto-powerdown condition to occur.
Auto-powerdown can be disabled when FORCEON and FORCEOFF are high, and should be done when driving
a serial mouse. With auto-powerdown enabled, the device is activated automatically when a valid signal is
applied to any receiver input. The INVALID output is used to notify the user if an RS-232 signal is present at any
receiver input. INVALID is high (valid data) if any receiver input voltage is greater than 2.7 V or less than – 2.7 V
or has been between – 0.3 V and 0.3 V for less than 30 µ s. INVALID is low (invalid data) if all receiver input
voltages are between – 0.3 V and 0.3 V for more than 30 µ s. Refer to Figure 5 for receiver input levels.
The TRS3243EC is characterized for operation from 0 ° C to 70 ° C. The TRS3243EI is characterized for operation
from – 40 ° C to 85 ° C.
± 15-kV ESD (HBM and IEC61000-4-2, Air-Gap Discharge) and ± 8-kV ESD (IEC61000-4-2, Contact Discharge)
protection on serial-port connection pins. The device meets the requirements of TIA/EIA-232-F and provides the
electrical interface between an asynchronous communication controller and the serial-port connector. This
combination of drivers and receivers matches that needed for the typical serial port used in an IBM PC/AT, or
compatible. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-V
supply. In addition, the device includes an always-active noninverting output (ROUT2B), which allows
applications using the ring indicator to transmit data while the device is powered down. The device operates at
data signaling rates up to 250 kbit/s and a maximum of 30-V/ µ s driver output slew rate.
Flexible control options for power management are available when the serial port is inactive. The
auto-powerdown feature functions when FORCEON is low and FORCEOFF is high. During this mode of
operation, if the device does not sense a valid RS-232 signal, the driver outputs are disabled. If FORCEOFF is
set low, both drivers and receivers (except ROUT2B) are shut off, and the supply current is reduced to 1 µ A.
Disconnecting the serial port or turning off the peripheral drivers causes the auto-powerdown condition to occur.
Auto-powerdown can be disabled when FORCEON and FORCEOFF are high, and should be done when driving
a serial mouse. With auto-powerdown enabled, the device is activated automatically when a valid signal is
applied to any receiver input. The INVALID output is used to notify the user if an RS-232 signal is present at any
receiver input. INVALID is high (valid data) if any receiver input voltage is greater than 2.7 V or less than – 2.7 V
or has been between – 0.3 V and 0.3 V for less than 30 µ s. INVALID is low (invalid data) if all receiver input
voltages are between – 0.3 V and 0.3 V for more than 30 µ s. Refer to Figure 5 for receiver input levels.
The TRS3243EC is characterized for operation from 0 ° C to 70 ° C. The TRS3243EI is characterized for operation
from – 40 ° C to 85 ° C.
Receiver
加入交流群
扫码添加小助手
加入工程师交流群
下载该资料的人也在下载
下载该资料的人还在阅读
更多 >
- TRS3243 3V至5.5V多通道RS-232线路驱动器和接收器数据表
- MAX3222 3-V和5.5-V多通道RS-232线路驱动器和接收器数据表
- TRS3232E-Q1,pdf(3-V to 5.5-V M
- MAX3227E,pdf(3-V to 5.5-V Sing
- MAX3238E,pdf(3-V TO 5.5-V Mult
- MAX3243E,pdf(3-V to 5.5-V Mult
- TRS3227,pdf(3-V to 5.5-V Singl
- TRS3238,pdf(3-V to 5.5-V Multi
- TRSF3243,pdf(3-V to 5.5-V Mult
- TRS3222E,pdf(3-V TO 5.5-V MULT
- TRS3223E,pdf(3-V TO 5.5-V MULT
- TRS3227E,pdf(3-V TO 5.5-V SING
- TRS3237E,pdf(3-V to 5.5-V Mult
- TRS3238E,pdf(3-V TO 5.5-V MULT
- TRSF3238E,pdf(3-V to 5.5-V Mul
- 电子工程师必备:MAX3243E RS-232接口芯片深度解析 95次阅读
- 探索TRS3243E:高性能RS - 232接口芯片的卓越之选 108次阅读
- 深入解析TRS3232E:3V至5.5V多通道RS - 232线驱动器和接收器 147次阅读
- 探索TRS3221E:高性能RS - 232接口芯片的全方位解析 142次阅读
- MAX3221E 3V 至 5.5V 单通道 RS - 232 线路驱动器和接收器:设计与应用全解析 109次阅读
- 探索TRSF3238E:3 - 5.5V多通道RS - 232线驱动器/接收器 527次阅读
- 低功耗与高保护的完美结合:TRS3318E RS - 232收发器的深度解析 493次阅读
- 3 - 5.5V 多通道 RS - 232 收发器 SN65C3238E/SN75C3238E 深度解析 534次阅读
- 探索TRS3237E:多通道RS - 232线驱动器/接收器的卓越性能 452次阅读
- 探索TRS3243:高性能RS - 232接口芯片的设计与应用 99次阅读
- 探索TRS3253E RS - 232收发器:特性、应用与设计要点 166次阅读
- 探索TRS3223 - Q1:高性能RS - 232收发器的卓越之选 132次阅读
- 汽车级RS - 232收发器TRS3232E - Q1:特性、参数与应用详解 222次阅读
- 探索 TRS3253E - EP:多功能 RS - 232 收发器的卓越性能 254次阅读
- TRS3122E 1.8V低功耗双路RS - 232收发器:设计与应用详解 244次阅读
下载排行
本周
- 1ECM96智能电测仪表使用说明书
- 3.41 MB | 7次下载 | 10 积分
- 2ECM72智能电测仪表使用说明书
- 2.07 MB | 2次下载 | 10 积分
- 3纳祥科技NX9020中文规格书,114 dB CODEC,国产替代CS4272
- 440.34 KB | 2次下载 | 免费
- 4 斯丹电子 | 磁传感技术在数据中心市场应用
- 614.56 KB | 2次下载 | 免费
- 5矽力杰 Silergy SY8303A 降压转换器 规格书 Datasheet 佰祥电子
- 815.36 KB | 1次下载 | 免费
- 6PC0815/PC0815A 850伏N沟道耗尽模式功率MOSFET技术手册
- 0.42 MB | 1次下载 | 免费
- 7WD1117产品规格书
- 763.67 KB | 1次下载 | 免费
- 8斯丹电子 | 数据中心传感器应用工程指南
- 6.95 MB | 次下载 | 免费
本月
- 1ECM96智能电测仪表使用说明书
- 3.41 MB | 7次下载 | 10 积分
- 2矽力杰 Silergy SY7215A 同步升压调节器 规格书 Datasheet 佰祥电子
- 1.12 MB | 5次下载 | 免费
- 3WTK6900FC 鼾声识别功能说明书V1
- 2.04 MB | 4次下载 | 免费
- 4SY50655 用于高输入电压应用的伪固定频率SSR反激式稳压器英文资料
- 1.01 MB | 3次下载 | 免费
- 5ECM72智能电测仪表使用说明书
- 2.07 MB | 2次下载 | 10 积分
- 6纳祥科技NX9020中文规格书,114 dB CODEC,国产替代CS4272
- 440.34 KB | 2次下载 | 免费
- 7华润微 CRTE280P06L2-G -60V Trench P-MOSFET 技术参数与应用解析
- 1.83 MB | 2次下载 | 免费
- 8 斯丹电子 | 磁传感技术在数据中心市场应用
- 614.56 KB | 2次下载 | 免费
总榜
- 1matlab软件下载入口
- 未知 | 935137次下载 | 10 积分
- 2开源硬件-PMP21529.1-4 开关降压/升压双向直流/直流转换器 PCB layout 设计
- 1.48MB | 420064次下载 | 10 积分
- 3Altium DXP2002下载入口
- 未知 | 233095次下载 | 10 积分
- 4电路仿真软件multisim 10.0免费下载
- 340992 | 191469次下载 | 10 积分
- 5十天学会AVR单片机与C语言视频教程 下载
- 158M | 183360次下载 | 10 积分
- 6labview8.5下载
- 未知 | 81606次下载 | 10 积分
- 7Keil工具MDK-Arm免费下载
- 0.02 MB | 73832次下载 | 10 积分
- 8LabVIEW 8.6下载
- 未知 | 65991次下载 | 10 积分
电子发烧友App





创作
发文章
发帖
提问
发资料
发视频
上传资料赚积分
评论