OPA631/OPA632 pdf datasheet (L

The OPA631 and OPA632 are low power, high-speed,
voltage-feedback amplifiers designed to operate on a
single +3V or +5V supply. Operation on ±5V or +10V
supplies is also supported. The input range extends
below ground and to within 1V of the positive supply.
Using complementary common-emitter outputs provides
an output swing to within 30mV of ground and
130mV of the positive supply. The high output drive
current and low differential gain and phase errors also
make them ideal for single-supply consumer video
products.
Low distortion operation is ensured by the high gain
bandwidth (68MHz) and slew rate (100V/ms), making
the OPA631 and OPA632 ideal input buffer stages to
3V and 5V CMOS converters. Unlike other low power,
single-supply amplifiers, distortion performance improves
as the signal swing is decreased. A low 6nV
input voltage noise supports wide dynamic range operation.
Channel multiplexing or system power reduction
can be achieved using the high speed disable line.
Power dissipation can be reduced to zero by taking the
disable line High.
The OPA631 and OPA632 are available in an industrystandard
SO-8 package. The OPA631 is also available
in an ultra-small SOT23-5 package, while the OPA632
is available in the SOT23-6. Where higher full-power
bandwidth and lower distortion are required in a singlesupply
operational amplifier, consider the OPA634
and OPA635.