资料介绍
The CY7C637xxC is an 8-bit RISC one-time-programmable
(OTP) microcontroller. The instruction set has been optimized
specifically for USB and PS/2 operations, although the microcontrollers
can be used for a variety of other embedded applications.
The CY7C637xxC features up to 16 GPIO pins to support
USB, PS/2 and other applications. The I/O pins are grouped
into two ports (Port 0 to 1) where each pin can be individually
configured as inputs with internal pull-ups, open drain outputs,
or traditional CMOS outputs with programmable drive strength
of up to 50 mA output drive. Additionally, each I/O pin can be
used to generate a GPIO interrupt to the microcontroller. Note
the GPIO interrupts all share the same “GPIO” interrupt vector.
The CY7C637xxC microcontrollers feature an internal oscillator.
With the presence of USB traffic, the internal oscillator
can be set to precisely tune to USB timing requirements (6
MHz ±1.5%). Optionally, an external 6-MHz ceramic resonator
can be used to provide a higher precision reference for USB
operation. This clock generator reduces the clock-related
noise emissions (EMI). The clock generator provides the 6-
and 12-MHz clocks that remain internal to the microcontroller.
The CY7C637xxC has 8 Kbytes of EPROM and 256 bytes of
data RAM for stack space, user variables, and USB FIFOs.
These parts include low-voltage reset logic, a Watchdog timer,
a vectored interrupt controller, a 12-bit free-running timer, and
capture timers. The low-voltage reset (LVR) logic detects
when power is applied to the device, resets the logic to a
known state, and begins executing instructions at EPROM
address 0x0000. LVR will also reset the part when VCC drops
below the operating voltage range. The Watchdog timer can
be used to ensure the firmware never gets stalled for more
than approximately 8 ms.
(OTP) microcontroller. The instruction set has been optimized
specifically for USB and PS/2 operations, although the microcontrollers
can be used for a variety of other embedded applications.
The CY7C637xxC features up to 16 GPIO pins to support
USB, PS/2 and other applications. The I/O pins are grouped
into two ports (Port 0 to 1) where each pin can be individually
configured as inputs with internal pull-ups, open drain outputs,
or traditional CMOS outputs with programmable drive strength
of up to 50 mA output drive. Additionally, each I/O pin can be
used to generate a GPIO interrupt to the microcontroller. Note
the GPIO interrupts all share the same “GPIO” interrupt vector.
The CY7C637xxC microcontrollers feature an internal oscillator.
With the presence of USB traffic, the internal oscillator
can be set to precisely tune to USB timing requirements (6
MHz ±1.5%). Optionally, an external 6-MHz ceramic resonator
can be used to provide a higher precision reference for USB
operation. This clock generator reduces the clock-related
noise emissions (EMI). The clock generator provides the 6-
and 12-MHz clocks that remain internal to the microcontroller.
The CY7C637xxC has 8 Kbytes of EPROM and 256 bytes of
data RAM for stack space, user variables, and USB FIFOs.
These parts include low-voltage reset logic, a Watchdog timer,
a vectored interrupt controller, a 12-bit free-running timer, and
capture timers. The low-voltage reset (LVR) logic detects
when power is applied to the device, resets the logic to a
known state, and begins executing instructions at EPROM
address 0x0000. LVR will also reset the part when VCC drops
below the operating voltage range. The Watchdog timer can
be used to ensure the firmware never gets stalled for more
than approximately 8 ms.
下载该资料的人也在下载
下载该资料的人还在阅读
更多 >
- PSoC 1 可编程片上系统CY8C24094_CY8C24794_CY8C24894_CY8C24994_ZH_001-47288_ZH 31次下载
- SRAM CY14B101Q1, CY14B101Q2, CY14B101Q3 1 Mbit (128 K × 8) Serial SPI nvSRAM 3次下载
- PSoC 1 可编程片上系统CY8C21123_CY8C21223_CY8C21323_001-63473_0A_V_ZH 15次下载
- CY7C68013A中文资料 438次下载
- 11CY7.pdf 电子管资料数据手册 8次下载
- 如何将CY7B951或CY7B952的5V PECL输出接至 27次下载
- 详细介绍CY7B991,CY7B992的信息及RoboClo 16次下载
- 基于CY7C63723/CY7C63722芯片的鼠标电路图及 604次下载
- CY7C63742/CY7C63743 pdf datash 114次下载
- CY25403/CY25423/CY25483 pdf da 10次下载
- CY25402/CY25422/CY25482 pdf da 15次下载
- cy2547/CY2545 pdf datasheet (Q 16次下载
- CY8C27243/CY8C27143/CY8C27443 22次下载
- CY7C4225/CY7C4235/CY7C4245 pdf 20次下载
- CY7C4425/CY7C4205/CY7C4215 pdf 12次下载
- 10W充电器IC CY2525D的工作原理和引脚说明 354次阅读
- 电源电路的EMC设计 457次阅读
- 充电器芯片CY3783A的简单介绍 707次阅读
- 基于Infineon开发板实现RT-Thread物联网DEMO 792次阅读
- 高速串行数据通信CY7B923芯片的性能特点及设计实例 3599次阅读
- 基于CY8C24894 PSoC的超声波测距系统解决方案 2900次阅读
- 基于CY8C24533芯片实现电动车自行车控制系统的应用方案 5325次阅读
- CY8CKIT-035电源管理扩展的特点性能及应用 1825次阅读
- 基于CY7C68013芯片的LED显示屏外部接口设计 1465次阅读
- 通过CY7C68013微控制器实现数据低速控制、高速传输的设计 4723次阅读
- 微雪电子CY7C68013A高速USB通信模块简介 2445次阅读
- 单片机中如何用C语言实现查表找到对应的值 7493次阅读
- 单片机中的CY与OV详细解析 3.2w次阅读
- 在研发和测试过程中的接地的问题 7248次阅读
- 基于XC3S400和CY7C68013多路数据采集电路的设计 2447次阅读
下载排行
本周
- 1TC358743XBG评估板参考手册
- 1.36 MB | 330次下载 | 免费
- 2开关电源基础知识
- 5.73 MB | 11次下载 | 免费
- 3嵌入式linux-聊天程序设计
- 0.60 MB | 3次下载 | 免费
- 4DIY动手组装LED电子显示屏
- 0.98 MB | 3次下载 | 免费
- 5基于FPGA的C8051F单片机开发板设计
- 0.70 MB | 2次下载 | 免费
- 651单片机窗帘控制器仿真程序
- 1.93 MB | 2次下载 | 免费
- 751单片机PM2.5检测系统程序
- 0.83 MB | 2次下载 | 免费
- 8基于51单片机的RGB调色灯程序仿真
- 0.86 MB | 2次下载 | 免费
本月
- 1OrCAD10.5下载OrCAD10.5中文版软件
- 0.00 MB | 234315次下载 | 免费
- 2555集成电路应用800例(新编版)
- 0.00 MB | 33566次下载 | 免费
- 3接口电路图大全
- 未知 | 30323次下载 | 免费
- 4开关电源设计实例指南
- 未知 | 21549次下载 | 免费
- 5电气工程师手册免费下载(新编第二版pdf电子书)
- 0.00 MB | 15349次下载 | 免费
- 6数字电路基础pdf(下载)
- 未知 | 13750次下载 | 免费
- 7电子制作实例集锦 下载
- 未知 | 8113次下载 | 免费
- 8《LED驱动电路设计》 温德尔著
- 0.00 MB | 6656次下载 | 免费
总榜
- 1matlab软件下载入口
- 未知 | 935054次下载 | 免费
- 2protel99se软件下载(可英文版转中文版)
- 78.1 MB | 537798次下载 | 免费
- 3MATLAB 7.1 下载 (含软件介绍)
- 未知 | 420027次下载 | 免费
- 4OrCAD10.5下载OrCAD10.5中文版软件
- 0.00 MB | 234315次下载 | 免费
- 5Altium DXP2002下载入口
- 未知 | 233046次下载 | 免费
- 6电路仿真软件multisim 10.0免费下载
- 340992 | 191186次下载 | 免费
- 7十天学会AVR单片机与C语言视频教程 下载
- 158M | 183279次下载 | 免费
- 8proe5.0野火版下载(中文版免费下载)
- 未知 | 138040次下载 | 免费
评论
查看更多