资料介绍
The TUSB1210 is a USB2.0 transceiver chip, designed to interface with a USB controller via a ULPI
interface. It supports all USB2.0 data rates (High-Speed 480Mbps, Full-Speed 12 Mbps and Low-Speed
1.5Mbps) in both Host and Peripheral modes. It additionally supports a UART mode and legacy ULPI
serial modes.
TUSB1210 also supports the OTG (Ver1.3) optional addendum to the USB 2.0 Specification, including
Host Negotiation Protocol (HNP) and Session Request Protocol (SRP).
TUSB1210 is optimized to be interfaced through a 12-pin SDR UTMI Low Pin Interface (ULPI), supporting
both input clock and output clock modes, with 1.8 V interface supply voltage.
TUSB1210 integrates a 3.3 V LDO, which makes it flexible to work with either battery operated systems or
pure 3.3 V supplied systems. Both the main supply and the 3.3 V power domain can be supplied through
an external switched-mode converter for optimized power efficiency.
TUSB1210 includes a POR circuit to detect supply presence on VBAT and VDDIO pins. TUSB1210 can be
disabled or configured in low power mode for energy saving.
TUSB1210 is protected against accidental shorts to 5 V or ground on its exposed interface (DP/DM/ID). It
is also protected against up to 20 V surges on VBUS.
TUSB1210 integrates a high-performance low-jitter 480 MHz PLL and supports two clock configurations.
Depending on the required link configuration, TUSB1210 supports both ULPI input and output clock mode
: input clock mode, in which case a square-wave 60 MHz clock is provided to TUSB1210 at the ULPI
interface CLOCK pin; and output clock mode in which case TUSB1210 can accept a square-wave
reference clock at REFCLK of either 19.2 MHz, 26 MHz. Frequency is indicated to TUSB1210 via the
configuration pin CFG. This can be useful if a reference clock is already available in the system.
interface. It supports all USB2.0 data rates (High-Speed 480Mbps, Full-Speed 12 Mbps and Low-Speed
1.5Mbps) in both Host and Peripheral modes. It additionally supports a UART mode and legacy ULPI
serial modes.
TUSB1210 also supports the OTG (Ver1.3) optional addendum to the USB 2.0 Specification, including
Host Negotiation Protocol (HNP) and Session Request Protocol (SRP).
TUSB1210 is optimized to be interfaced through a 12-pin SDR UTMI Low Pin Interface (ULPI), supporting
both input clock and output clock modes, with 1.8 V interface supply voltage.
TUSB1210 integrates a 3.3 V LDO, which makes it flexible to work with either battery operated systems or
pure 3.3 V supplied systems. Both the main supply and the 3.3 V power domain can be supplied through
an external switched-mode converter for optimized power efficiency.
TUSB1210 includes a POR circuit to detect supply presence on VBAT and VDDIO pins. TUSB1210 can be
disabled or configured in low power mode for energy saving.
TUSB1210 is protected against accidental shorts to 5 V or ground on its exposed interface (DP/DM/ID). It
is also protected against up to 20 V surges on VBUS.
TUSB1210 integrates a high-performance low-jitter 480 MHz PLL and supports two clock configurations.
Depending on the required link configuration, TUSB1210 supports both ULPI input and output clock mode
: input clock mode, in which case a square-wave 60 MHz clock is provided to TUSB1210 at the ULPI
interface CLOCK pin; and output clock mode in which case TUSB1210 can accept a square-wave
reference clock at REFCLK of either 19.2 MHz, 26 MHz. Frequency is indicated to TUSB1210 via the
configuration pin CFG. This can be useful if a reference clock is already available in the system.
下载该资料的人也在下载
下载该资料的人还在阅读
更多 >
- ENC424J600/624j600独立10/100以太网控制器与SPI或并行接口数据表 22次下载
- NUC900的独立库 0次下载
- ENC28J60 datasheet 16次下载
- BQ24618,pdf(Stand-Alone Synchr 17次下载
- UCC3956,pdf(Switch Mode Lithiu 14次下载
- BQ24630,pdf(Stand-Alone Synchr 12次下载
- TUSB6250,pdf(USB 2.0 to ATA/AT 42次下载
- TUSB3410,TUSB3410I,pdf(USB to 71次下载
- NNI B-ISUP Signalling Test Sof 11次下载
- TPIC44H01 WinHelp Data Sheet: 18次下载
- 基于TUSB6020的USB OTG接口设计 28次下载
- LP5550,pdf datasheet (Technolo 9次下载
- LP5551,pdf datasheet (Technolo 25次下载
- DS8102 pdf datasheet (Dual Del 14次下载
- MX98224EC pdf datasheet (24-po 8次下载
- USB-C和TYPE-C的区别 usb接口是充电口吗 708次阅读
- USB基础学习:USB体系结构介绍 3697次阅读
- 如何低成本实现USB Type-C接口 2243次阅读
- USB23年发展史,多了什么变化? 8.2w次阅读
- 微雪电子USB集线器|USB HUB HAT简介 2575次阅读
- digilent网络接口控制器简介 1393次阅读
- USB接口的应用及USB设备具有哪些优势 9744次阅读
- 汽车胎压监测系统的原理图 3.9w次阅读
- USB接口的通讯原理和故障解决 9830次阅读
- 四种USB接口的引脚定义和封装 7.5w次阅读
- 你以为你了解的USB就是你了解的USB吗? 8403次阅读
- USB 3.2接口的特征, USB 3.0和USB 2.0的区别 8.4w次阅读
- mini usb和micro usb的区别 15w次阅读
- micro usb接口定义图_micro usb接线图 73.5w次阅读
- USB 3.1助力USB Type-C高飞 2014次阅读
下载排行
本周
- 1TC358743XBG评估板参考手册
- 1.36 MB | 330次下载 | 免费
- 2开关电源基础知识
- 5.73 MB | 11次下载 | 免费
- 3嵌入式linux-聊天程序设计
- 0.60 MB | 3次下载 | 免费
- 4DIY动手组装LED电子显示屏
- 0.98 MB | 3次下载 | 免费
- 5基于FPGA的C8051F单片机开发板设计
- 0.70 MB | 2次下载 | 免费
- 651单片机窗帘控制器仿真程序
- 1.93 MB | 2次下载 | 免费
- 751单片机PM2.5检测系统程序
- 0.83 MB | 2次下载 | 免费
- 8基于51单片机的RGB调色灯程序仿真
- 0.86 MB | 2次下载 | 免费
本月
- 1OrCAD10.5下载OrCAD10.5中文版软件
- 0.00 MB | 234315次下载 | 免费
- 2555集成电路应用800例(新编版)
- 0.00 MB | 33566次下载 | 免费
- 3接口电路图大全
- 未知 | 30323次下载 | 免费
- 4开关电源设计实例指南
- 未知 | 21549次下载 | 免费
- 5电气工程师手册免费下载(新编第二版pdf电子书)
- 0.00 MB | 15349次下载 | 免费
- 6数字电路基础pdf(下载)
- 未知 | 13750次下载 | 免费
- 7电子制作实例集锦 下载
- 未知 | 8113次下载 | 免费
- 8《LED驱动电路设计》 温德尔著
- 0.00 MB | 6656次下载 | 免费
总榜
- 1matlab软件下载入口
- 未知 | 935054次下载 | 免费
- 2protel99se软件下载(可英文版转中文版)
- 78.1 MB | 537798次下载 | 免费
- 3MATLAB 7.1 下载 (含软件介绍)
- 未知 | 420027次下载 | 免费
- 4OrCAD10.5下载OrCAD10.5中文版软件
- 0.00 MB | 234315次下载 | 免费
- 5Altium DXP2002下载入口
- 未知 | 233046次下载 | 免费
- 6电路仿真软件multisim 10.0免费下载
- 340992 | 191186次下载 | 免费
- 7十天学会AVR单片机与C语言视频教程 下载
- 158M | 183279次下载 | 免费
- 8proe5.0野火版下载(中文版免费下载)
- 未知 | 138040次下载 | 免费
评论
查看更多